If you are planning to construct a heavy duty project such as a bridge, a tower or a highway then make sure to check the moisture of the soil where the project is planned to be built, therefore the amount of wetness of the soil should be checked.
Resistance meter technique - Once the moisture has been found, the next step is to find the level of moisture. This can be done by passing a current through two metal slabs which are dug into the soil and then noting down the resistance.
Vicat machine - Once the Vicat Machine is installed on the floor then it can very easily calculate the initial as well as the final time of the cement motor.
Gillmore Needle Device - Gilmore Needle Device helps in calculating the time which is require to transform the mortar which is prepared ti the hydraulic.
Flow Table Test - Flow Table Test helps in monitoring the flow table performance as it finds out the consistency of concrete motor. It helps I finding out the correct consistency as it helps in deciding the overall strength of the finished project. There are a variety of flow table test available, some are even manual and is available at the most affordable.
Above were just a few uses of Concrete testing equipment which are widely used ,other than that they are many more Concrete testing equipment which are used in order to get the best results.